RA272製作記 4 -The modeling of HONDA RA272 vol.4
2015/09/20
ノーズコーンのツメは接着成功！！本体にはめ込んで、うーん、まっいいか。もう外さないだろうね。研ぎ出し、スミ入れもこんなもんでOK。メッシュをノーズとエンジンカウルにつけようと思いましたけど、やめました。なんかこれで十分な気がしてきました。
The adhesion of the nail of the nose cone succeeded. It was connected to the main body well. I think that I do not take it off anymore. I think that this is enough for a grind and the shadowing. I intended to add metal mesh to a nose and an engine cowl, but stopped it. I felt it was to here, and enough.
さて、鬼門のデカール貼りですが３時間かかりました。デカールソフター使用しましたが、少ししわが残り完璧とは行きませんでした。ちょっと塗装修正が必要ですが、とりあえずこれで完成としましょう。
It is the decare work of the unlucky direction. It took three hours before I put all it. I used decare softer, but some wrinkles were left in the decare. After all I was not able to completely put it. Repair by some painting is necessary, but is completion.
久々の完成品です。割と早い完成でした。頑張れHONDA。
It is after a long absence that I finished the product. This completion was early. Keep going HONDA!